13771031224 13771172819 13771481377
Contact Us

Wuxi Korer Stainless Steel Co.,Ltd.
Add:No.269,Jincheng Road East,Wuxi New Dist.Jiangsu,China
Zip:214111
Website:www.pocketfad.com/www.korer.net
Domestic Dept.
Contact Person:Linda He
Tel:+86-510-88230601
Fax:+86-510-88230505
Mobile:+86-13771031224

Home >> News >> Effect of solution treatment on seamless stainless steel pipe
Effect of solution treatment on seamless stainless steel pipe
News Source: | Release Time:2019-12-27

For stainless steel seamless pipe, the three elements of solution treatment are temperature, holding time and cooling rate. The effect of solution treatment on stainless steel seamless pipe is as follows:

1. It is particularly important for raw materials to make the structure and composition of seamless stainless steel pipe uniform and consistent, because the rolling temperature and cooling rate of each section of hot-rolled pipe are different, resulting in the inconsistency of microstructure. At high temperature, the activity of atoms increases, the σ phase dissolves, and the chemical composition tends to be uniform. After rapid cooling, the homogeneous single-phase structure is obtained.

2. Eliminate work hardening to facilitate subsequent cold working. After solution treatment, the distorted lattice was recovered, the elongated and broken grains recrystallized, the internal stress was eliminated, the tensile strength of steel wire decreased and the elongation increased.

3. The corrosion resistance of stainless steel pipe was restored. Because of the carbide precipitation and lattice defect caused by cold working, the corrosion resistance of stainless steel tube is decreased. After solution treatment, the corrosion resistance of stainless steel seamless pipe recovered to a good state.

The solution temperature is mainly determined by chemical composition. Generally speaking, the solution temperature should be increased for the grades with many kinds of alloy elements and high content. Especially for the steel with high content of Mn, Mo, Ni and Si, the softening effect can be achieved only by increasing the solution temperature and making it fully dissolved.

However, when the solution temperature is high, the carbides of stabilized elements are fully dissolved in austenite, and then precipitate at grain boundaries in the form of Cr23C6 in the subsequent cooling, resulting in intergranular corrosion. In order to keep the carbides (TIC and NBC) of stabilized elements from decomposition and solid solution, the lower limit solution temperature is generally adopted.

Contact Us
  • Add:No.269,Jincheng Road East,Wuxi
  • Contact Person:Linda He
  • Tel:+86-510-88230601
  • Mobile:+86-13771031224
Send Email
*Name:
*Phone:
*E-mail:
*Message:
精品国产免费第一区二区三区_精品国产品国语在线不卡_精品国产在天天线在线麻豆